L8 Software
Manual
×
Menu
Index

7.7. 2D icon / 3D Model / Light Distribution Settings

 
2D icon / 3D Model / Light Distribution Settings
 
7.7. 2D icon / 3D Model / Light Distribution Settings
1

2D icon

1. 2D icon
2D icon
By clicking 2D icon button you can select the icon for 2D display and set the associated 3D fixture model (MESH). 
The content of 2D Icon. Changes depending on each fixture category (Movinghead, Scanner, etc.).
 
 
2

Lens

2. Lens
Select the basic light distribution for the fixture.
3

Lumen

3. Lumen
Sets the Lumen value for the fixture. The Lux value at a fixed distance calculated from the beam angle set by Deg.10%,
which will be described later, is displayed at the bottom and changes as the Lumen value and Deg.10% value are adjusted.
4

Temp

4. Temp
Sets the color temperature of the light source.
5

Drop

5. Drop
Set the light distribution curve. 
The rough light curve is determined by the light distribution selected by Lens, but you can mainly adjust the position of the 50% drop with the Drop parameter. 
"50% R-XX" and "10% R-XX" are displayed at the bottom, and change as needed as the Drop parameter is adjusted.
6

Deg.10%

6. Deg.10%
Sets the beam angle for a 10% drop. This parameter sets the maximum beam angle.
7

Frost

7. Frost
Adjust the frost effect. It is mainly effective for wash light distribution.
8

xAspect

8. xAspect
Adjust the aspect ratio of the light distribution. At 1.000, the aspect ratio is 1: 1.
9

Max Lux

9. Max Lux
Max Lux Calculator
10

MIPS

10. MIPS
Light Correction Preview