Hello,

Can you create for me the following fixtures?

Yagang (Silver Star) Golden Scan LT-575 (no information about it)
Yagang (Silver Star) YX-2105
Yagang (Silver Star) YX-2106
Showtec RGB Strobe 3000
Strand Follow Spot CSI (1000W HMI follow spot, not dimmable, no DMX, but can you create one which can be controlled by DMX in order to simulate completely my design?)

Is it possible to add smoke remote controlled by DMX?

Thanks!

Nathanael

Hello, Nathanael.
We will process your request as soon as possible.

You can also create some fixtures by yourself. See "Constructor" section in "Browse Fixture" dialog.

Hello, nsunier

Unfortunately we can make drivers only on those devices on which we have full documentation.
I shall try to make those devices on which you gave me uals, but in them does not suffice timing and gobos.
So when all will be ready, we will tell you.
But after you must substitute necessary gobos and timing in the "Constructor".

Hello,

Can you tell me exactly which information you need to create accurate models? Then I will try to contact the ufacture in order to get these informations.

I really need to get accurate models. I am a beginner in use of LC. If models are correct and I do not need to edit them, it will be easier for me to start.

Thanks for your work.

nsunier

Your devices have channel-scan speed adjustment, so I need the detailed description of this channel - the table and maximum speed of movement on Pan and Tilt.
Also I need to see gobo-pictures in sequence on the fixed and rotating wheel.

Hello,

I have found the ual for the Golden Scan LT-575.

I have sent an email to the ufacture, I am waiting...

Regards.

Hello,

I have more photometric informations about both moving heads:

Yagang (Silver Star) YX-2105
Yagang (Silver Star) YX-2106

Are gobo and filters pictures big enough?
So, now you only need timings?
Do you need something else in order to achieve creating the five asked models?

Thanks!