I am looking for a Meteor Promover fixture. It is a Taiwan clone of a Source 4 Par used as
the head on a moving yoke.

Hi Stan, is this the one you are looking for?:

ProMover P64, http://www.meteor-global.com/products-movingHeads.php

Hello Gordon and Stan,

I can make driver on this fixture. But I need correct manual with photometric, DMX-mapping and Timming.
In any case we have driver and model on ClayPaky Pin Scan it looks really similar. Can you check it?

Hi Nik,

Sorry bout that, the manual for the Promover P64 was on the previous page I posted, but farther down.

- Here is pdf with dmx mapping, etc: http://www.meteor-global.com/technical/ ... 20Yoke.pdf.

- The photometrics are the same as our fixed Par-64 MFL

- The actual 3D model for ClayPaky PinScan should be okay for now because they need it for a show soon. Can we just increase complete model size by about 50%? ....I tried to increase the size in the .inf file, but was unsure which parameter it was.

- I couldn't find any timing info yet.

Thanks!

Hi Nikolay.

Promover profile is done. I will send to you for verification.

Hi Gordon,

That's GREAT.
I'm waiting for driver from you. After verification I'll place it hear with correct 3D-Model.