Is it possible to move around one the position that you are on that moment. For example I wound to make a movie of 360 degrees when i am inside of the boulding. A sort of panorama shot from the same position.

Then a question about moving the camera. Is there special hardware that can be used to move the camera smoothly. Ive i use the mouse its moves always a little bit shaking.

All ideas are welcome.

Yes, camera always walk around World Center, which may be placed anywhere.
To move the camera smoothly first you should have computer with a good videocard (to play FPS high), than you will probably need a good gaming hi-res mouse. 3Dconnexion mouse will help you also.
And finally you can patch the camera to DMX and operate it from lighting console with 16bit accuracy.

Hi Dmitriy,

I understand that the camera is always moved around the center. What I wound is moving the camera from one point 360 degrees around the camera

For example. I am in the middle of a building and i wound to make a movie from inside of the building. The building is 10m by 10m and 5m high. Ive i move the camera around the
center. the camera is moving also out of the building. And that is not what i Wound.

I have a project where i have to show how it looks inside of the building.

Another point is the speed that the camera moved arround. Is there a way to control this speed. Know it started slowly and its going faster if you moves a few time around.

A lot of questions. So I hope you can help me.

If you patch the Camera to DMX, the Distance fader @144 is equal to the zero distance from a World Center. You can also do that in "Full Processing" mode and control the camera from a virtual camera fixture.

The motion speed will depend from your Fade Time from one point to another.

Here I am back white a question about the 3d Mouse from 3D Connexion.

I was looking for one type of these models (Space Navigator USB).

Support Lightconverse these model?

Use search on forum:
viewtopic.php?f=6&t=609&