Hello Again.
I'd like to ask if its possible to add some new feautures to the next releases.
1st thing we're looking for is the option to load and Save complete Stages and Fixtures. We're the ones from Germany who use your programm only for Visualisation and it would make life much easier.
Another thing that would be great is the option to move the Camera in Visualisation Mode via the 4 cursor keys.

We also recognized that we have problems if we try to run the DMX-Signal through your Dongle (Lightdesk --> Lightconverse IN -->Lichtconverese OUT --> Moving head). In visualisation everything is fine but the moving Head we connected to the output of your Dongle sometimes makes short moves to another position even if we didn't change anithing on our light desk. Is this a Bug or did we forget to do anything? We Muted all Chanels generated by lightconverse.

Would be great to see some of our suggestions applied!

Greets Fabian

Ok
In the next software release we will add some 'Action' based functions for camera position. It is possible to programm Actions on hot keys and use in your work. For the near future multi-project possibility will be able too.

About movinghead short moves. Is your DMX line ok? You must connect Terminator in the end of line. Try to change a physical position of the device in the signal bus.

PS. Do you use a fullscreen video mode for the camera?
In this mode you can move camera position by mouse motions with pressed right click. Motions with left click pressed will rotate a camera. Mouse wheel rotate camera in vertical.

'Actions' for hot-key camera control are added now.
Please download lc.exe file release #165.
http://lightconverse.de/lc/download/index.htm

WOW, that's FAST!
Thank's a lot!

Fabian